Snappi Seat Standalone User Manual
Document No: 053-07 v5
Page 38 of 54
January 2019
Snappi Seat Standalone User Manual.doc
To fit the grip rail, place the vertical tubes
into the receivers on either side of the seat
unit (See Fig 6.3.2).
Note there may be a small plastic cap in the
top of the receiver. If this is the case,
remove the cap using a small flat bladed
screwdriver before fitting the grip rail.
Once you have the vertical tubes in place,
put the thumb screw in the hole on the back
of the receiver and tighten until the tube is
being held securely
– do not over-tighten.
In order for the occupant to reach the grip
rail, the vertical tubes are angled. This
enables the grip rail to be fitted either
leaning towards the occupant or away from
them.
When the seat depth is extended, the grip
rail will need to be fitted with the vertical
tubes angled towards the occupant (See Fig
6.3.3). When the seat depth is short, the
grip rail should be fitted angled away from
the occupant (See Fig 6.4.4).
6.4: Playtray
– not suitable for rearward facing Snappi
The Snappi playtray offers height, depth and
angle adjustment, so that it can be adapted
to suit your needs. It is available in clear or
black. (Clear playtray shown for illustrative
purposes Fig 6.4.1).
The playtray comes supplied with the
following:
•
2 angle adjustable vertical stems
(marked A and B) in the bag.
•
2 depth adjustment brackets and
thumbscrews (fitted to the tray, also
marked A and B).
•
2 additional thumbscrews for the seat
receiver brackets in the bag.
Fig 6.4.1
Fig 6.3.2
Fig 6.3.3
Fig 6.3.4
