Snappi Seat Standalone User Manual
Document No: 053-07 v5
Page 41 of 54
January 2019
Snappi Seat Standalone User Manual.doc
6.5: Pommel
If
the
Pommel
is
ordered
as
a
replacement item then you will just
receive the pommel itself;
•
Pommel bracket, block, pads and
cover (assembled)
If the Snappi Seat was supplied without a
pommel then you will need the pommel
mounting kit (SN9654) as below;
•
Pommel mounting bracket
•
M6 x 10 wing nut
•
M6 x 16 socket button (x 2)
•
Form A Washer (x 2)
•
M6 Dome Nut ( x 2)
Fig 6.5.1
Fig 6.5.2
To fit the pommel to the seat:
If the Snappi Seat was supplied with a pommel
at the time of purchase the mounting bracket
will already be fitted. If not, you will need to
attach the mounting bracket into the two holes
on the front of the seat.(See Fig 6.5.2)
To do this, position the mounting bracket on
the front of the seat and put the M6 x 16
socket buttons (screws) through the 2 holes in
the mounting bracket and through the 2 holes
in the seat. Put a washer and a dome nut on
the end of each socket button and tighten.
Slide the vertical stem of the pommel into
the slot, with the body of the pommel
sitting over the seat.
Screw the wing nut into the centre hole of
the mounting bracket and tighten to
secure the pommel.
Adjust the height of the pommel as
required to clear any seat pads and the
cover.
To change the height, loosen the wing
nut, adjust to the required position, and
then retighten.
Fig 6.5.3
