WE310F5-X IP2WiFi Legacy AT Command Reference Guide
80664ST11079A Rev. 3
Page 38 of 79
2021-10-25
Not Subject to NDA
AT+WREGDOMAIN=?
Synchronous Response
Table 38: Get Regulatory Domain Synchronous Response.
Responses
Remarks
REG_DOMAIN=FCC
OK
Success
Example 1
AT+WREGDOMAIN=?
REG_DOMAIN=FCC
OK
Where possible values of REG_DOMAIN are FCC, ETSI, TELEC
7.1.2.
Operation Mode
Command Description
This command is used to set the wireless mode and related parameters.
Command Syntax
AT+WM=<wireless mode>[,<beacon interval in LAP mode>,<broadcast
ssid in LAP mode>,<no. of stations allowed in LAP mode>,<DTIM
period in LAP mode>,<inactivity timeout in LAP
mode>,<reserved>,<rate adaptation-device type>,<rate adaptation-
minimum application throughput>]<CR>
Note/Tip: Do not issue AT+WA command when Telit node is in WiFi
direct (P2P) mode. To issue AT+WA command, switch the Telit node to
either Station mode or Limited-AP mode using AT+WM command.
Parameter Description
Table 39: Operation Mode Parameters.
Parameter
Optional/Mandatory
Value
Description
wireless mode
Mandatory
0: Wi-Fi station mode 1:
Reserved
2: Wi-Fi limited AP mode
3: Wi-Fi direct
mode(P2P) (Not
Supported)
4: Reserved
6: Provisioning AP mode
(Not Supported)
Default value- 0
It specifies the wireless mode to be
set.
Note: When this parameter is set to 3,
do not issue AT+WA command. To
issue AT+WA command, set this
parameter to either 0 (Station mode)
or 2 (Limited-AP mode).