WE310F5-X IP2WiFi Legacy AT Command Reference Guide
80664ST11079A Rev. 3
Page 43 of 79
2021-10-25
Not Subject to NDA
7.2.2.
Security Configuration
7.2.2.1.
Security Setting
Command Description
This command is used to configure the Telit node with different security configuration.
Command Syntax
AT+WSEC=n
Parameter Description
Table 47: Security Setting Parameters.
Parameter
Optional/Mandatory
Value
Mode
Description
n
Mandatory
0 (default)
Auto security (All)
The Serial to Wireless
Application supports
either one of the Values.
This strict security
compliance is not
applicable for WPS
feature.
1
Open security
2
WEP security (Not Supported)
4
WPA-PSK security (TKIP only)
8
WPA2-PSK security (AES only)
16
WPA Enterprise (Not
Supported)
32
WPA2 Enterprise (Not
Supported)
64
WPA2-AES+TKIP security (Not
Supported)
Note:
1> In AP mode, only Open and WPA-AES as security mechanism is supported.
2> Enterprise security is supported in Station mode and not supported in limited AP mode.
3> Concurrent mode AP configuration settings varies from normal Limited AP mode configuration.
4> Telit module is unsuccessful to associate to an AP (WPA personal) when configured with AES for both Multicast and
Unicast (as the Group Key Handshake timeout is (0x0010))
Security: WEP-64 Open/Shared, WEP-128 Open/Shared,
WPA-Personal (TKIP), WPA2-Personal (AES),
WPA2-Personal (AES+TKIP),
WPA Enterprise (TKIP), WPA2-Enterprise (AES),
WPA2-Enterprise (AES+TKIP). 6>Only TKIP is supported in WPA
Synchronous Response
Table 48: Security Setting Synchronous Response.
Responses
Remarks
OK
Success
ERROR:INVALID INPUT
If parameters are not valid.
(
n
value is other than above mentioned value)