WE310F5-X IP2WiFi Legacy AT Command Reference Guide
80664ST11079A Rev. 3
Page 23 of 79
2021-10-25
Not Subject to NDA
Parameter Description
Table 12: Enable Legacy Command Mode Parameters.
Parameter
Optional/Mandatory
Value
Description
n
Mandatory
0, 1
It specifies the mode in which
the current AT commands are
executed, where:
0-Enables New AT command,
1-Enables Legacy command.
Note: Once this command is issued, the system resets and starts with the configured command mode.
Synchronous Response
Table 13: Enable Legacy Command Mode Synchronous Response.
Responses
Remarks
OK
Success
ERROR:INVALID INPUT
If parameters are not valid. (Other than 0 and 1)
6.2.3.
Boot Reason
Command Description
This command identifies the reason for system reset.
Command Syntax
AT+YBR
Response
+YBR:<Boot Reason>
Response Parameter Description
Table 14: Boot Reasons Parameters.
Parameter
Range
Type
Description
Boot Reason
N/A
Hardware Reset,
Watchdog Reset,
Software Reset,
Exception Hard Fault,
Exception Memory
Management Fault,
Exception Usage Fault,
Exception Bus Fault
It specifies the boot
reason.
Synchronous Response
Table 15: Boot Reasons Synchronous Response.
Responses
Remarks
OK
Success
ERROR:INVALID INPUT
If parameters are not valid. (Other than 0 and 1)
