WE310F5-X IP2WiFi Legacy AT Command Reference Guide
80664ST11079A Rev. 3
Page 26 of 79
2021-10-25
Not Subject to NDA
valid till: Fri, 13 Dec 1901 17:31:43 GMT
OK
Profile Setting
Telit node supports different operating modes with various settings pre-configured to
work with the system. A pre-defined set of variables can be stored in a profile. Telit node
currently supports storing two different profiles (profile0 and profile1).
The following AT commands are sequentially executed for setting a profile:
–
AT&V - To view the current profile
–
AT&W - To write to profile settings
–
ATZn - To load a profile
–
AT&Y - To reboot with particular profile
–
AT&F - To factory Reset
6.4.1.
Get Profile
Command Description
This command is used to get the information of current profiles (Profile 0 and Profile 1)
and their saved parameter values in ASCII format. The details of profile parameters are
described in Save Profile.
Command Syntax
AT&V
Synchronous Response
Table 19: Get Profile Synchronous Response.
Responses
Remarks
ACTIVE PROFILE
C0 &Y0 E1 V1 B=9600,8,N,1 &K0 &R0
+NDHCP=0 +NSET=192.168.1.99,255.255.255.0,192.168.1.1
+DNS1=0.0.0.0, +DNS2=0.0.0.0
+WM=0 +WAUTO=0,"GSDemoKit",,6
+WRETRY=5 +WP=0 +WRXPS=1 +WRXACTIVE=0
+NAUTO=0,1,192.168.1.1,8
+WAUTH=0 +WWPA="Serial2Wifi"+PSK-valid=0 +SSID=
+WWEP1=1234WWEP2=
S0=01000 S1=00500 S2=00500 S3=00003 S4=00010 S5=00150 S6=00050
S7=00020 S8=01400
+BDATA=0+WSEC=0+ASYNCMSG=0
STORED PROFILE 1
Success
The number of profiles depends upon the
default configuration of the module.
