WE310F5-X IP2WiFi Legacy AT Command Reference Guide
80664ST11079A Rev. 3
Page 63 of 79
2021-10-25
Not Subject to NDA
Parameter Description
Table 73: Standby Parameters.
Parameter
Optional/Mandatory
Value
Description
x
Mandatory
x
=Standby time
in milliseconds
This is the Standby time in
milliseconds. If a delay time is
provided, the Standby count begins
after the delay time has expired.
DELAY TIME
Optional
in milliseconds
This is the delay in milliseconds from
the time the command is issued to the
time when the module goes to
Standby.
ALARM1 POL
Not Supported
0 (high-to-low)
1 (low-to-high)
This is the polarity of the transition at
pin RTC_IO_1 of the module which
will trigger an alarm input and waken
the TELIT node from Standby. A value of
0 specifies a high-to-low transition as
active; a value of 1 specifies
low-to-high.
ALARM2 POL
Not Supported
1 (low-to-high)
This is the polarity of the transition at
pin RTC_IO_2 that triggers an alarm
input, using the same convention used
for Alarm1.
Note: Specifying an alarm polarity also enables the corresponding alarm input.
Synchronous Response
Table 74: Standby Synchronous Response.
Responses
Remarks
OK
Success
ERROR:INVALID INPUT
If parameters values are not valid. (Other than 0 and 1)
9.2.2.
Deep Sleep
Command Description
This command is used to enable the TELIT
node’s power
-saving Deep Sleep processor
mode.
Command Syntax
AT+PSDPSLEEP
Usage
When enabled, the TELIT node will enter the power-saving Deep Sleep mode when no
actions are pending. In Deep Sleep mode, the processor clock is turned off, and TELIT
node power consumption is reduced.
