WE310F5-X IP2WiFi Legacy AT Command Reference Guide
80664ST11079A Rev. 3
Page 37 of 79
2021-10-25
Not Subject to NDA
7.
WIRELESS
Wireless Generic
7.1.1.
Regulatory Domain
7.1.1.1.
Set Regulatory Domain
Command Description
This command is used to configure the
Telit node’s parameters to the requested
regulatory domain.
Command Syntax
AT+WREGDOMAIN=<Regulatory Domain>
Parameter Description
Table 36: Set Regulatory Domain Parameters.
Parameter
Optional/
Mandatory
Value
Regulatory
Domain
Supported
Channels
Desired Power Level
Regulatory Domain
Mandatory
Internal PA
(0 as default)
Internal PA (2 as
default)
0 (default)
FCC
1 to 11
0-7
2-15
1
ETSI
1 to 13
0-7
4-15
2
TELEC
1 to 14
0-7
2-15
The Regulatory domain set is required only once since it is being updated in the
Flash.
Synchronous Response
Table 37: Set Regulatory Domain Synchronous Response.
Responses
Remarks
OK
Success
ERROR:INVALID INPUT
If parameters are not valid.
(If Register domain value is other than 0-3)
7.1.1.2.
Get Regulatory Domain
Command Description
This command is used to output the current regulatory domain of the wireless interface
to the serial port.
Command Syntax
