Telit Wireless Solutions WE310F5-X, Reference Manual

Page: 30 / 79

WE310F5-X IP2WiFi Legacy AT Command Reference Guide
80664ST11079A Rev. 3 Page 30 of 79 2021-10-25
Not Subject to NDA
Parameter Values Reference
Protocol TCP, UDP
DHCP Client, 67
Server Port Number Any valid port
Server IP Address Any valid IP address
Host Name Valid Domain name
Wireless Interface Security Configuration
PSK Valid Valid, Invalid WPA-PSK and WPA2-PSK Key Calculation,
45
PSK-SSID Any valid SSID, used for PSK key
computation
WPA Pass Phrase
WPA-PSK and WPA2-PSK Passphrase, 44
TCP/IP Configuration
DHCP Mode Enabled, Disabled
DHCP Client, 67
IP Address Valid IP address
IP Address, 73
Net Mask Address Valid mask
Default Gateway Address Valid IP address
DNS1 Valid DNS1 IP address DNS Address, 72
DNS2 Valid DNS2 IP address
UART Configuration
Echo Mode Enabled, Disabled
Echo, 67
Verbose Mode Enabled, Disabled
Verbose, 68
Hardware Flow Control Mode Enabled, Disabled
Hardware Flow Control, 18
6.4.6. Restore Profile
Command Description
This command is used to restore current profile to factory default values. The factory
default values are stored in RAM, and will be lost after each power cycle.
Upon deployment of this command, the current configuration variables are reset to the
factory defaults. These defaults are defined by macro values in the configuration header.
Issuing this command resets essentially all configuration variables.
Command Syntax
AT&F
Synchronous Response
Table 27: Restore Profile Synchronous Response.
Responses Remarks
OK Success