WE310F5-X IP2WiFi Legacy AT Command Reference Guide
80664ST11079A Rev. 3
Page 58 of 79
2021-10-25
Not Subject to NDA
Note/Tip:
1).NCM with PS-Poll is does not support web provisioning (web page
related) features.
Parameter Description
Table 70: IEEE PSPoll Listen Interval Parameters.
Parameter
Optional/Mandatory
Value
Description
Enable
Mandatory
0
Disable IEEE PS
1
Enable IEEE PS (wakeupType tells
whether DTIM or Listen interval)
2
Configure IEEE PS
Note: Enable/disable is used run-time to control radio while remaining parameters will be used only for
configuration when required. If configuration is not specified, last configuration will be used.
listenInterval
Not Supported
N/A
Reserved for future use.
WakeupType
Not Supported
0
DTIM based wakeup
wakeupInterval
Not Supported
N/A
Reserved for future use.
BeaconWaitTimeout
Not Supported
N/A
Reserved for future use.
DataRxType
Not Supported
N/A
Reserved for future use.
ActiveToOffTimeout
Not Supported
N/A
Time to be in active radio state if
DataRxType is switched to active mode.
Time is extended whenever a frame is
received and radio state is turned off
after timeout. A null frame is sent to AP
to indicate transition to doze state.
SwitchToActivePerio d Not Supported
N/A
Reserved for future use.
Note: All the Optional parameters need to configure with their default values.
Example 1
AT+WRXACTIVE
If AT+WRXACTIVE = 1, then the radio is always ON. No power save
is done in this case. Regardless of what the parameters for the
other two commands are, the radio will receive all the packets.
Rest of the commands are “Don’t Care.”
Example 2
AT+WRXPS
If AT+WRXPS = 1, Regardless of what the parameters for
AT+WIEEEPSPOLL are, the STA will wake up for every beacon.
AT+WIEEEPSPOLL is a “Don’t
Care” in this case.
If AT+WRXPS = 0, the STA will not wake up for every beacon.
Based on the AT+WIEEEPSPOLL, the wake will be decided as
explained further.
