18
PRISM Field Upgrade Kit Instructions
20.
Perform steps 9 to 13 in reverse order to reinstall Mixed Media and GPIO
board back into instrument. Tighten the four Mixed Media board bracket
screws to 0.6 N·m (5.31 in-lb).
21.
Slide the Mixed Media module under the fixed hardware turrets.
Figure 25: Slide the Mixed Media module back into chassis
22.
Secure the back panel to the instrument. Tighten two side screws to 0.9 N·m
(7.97 in-lb).
NOTE.
With your finger, put pressure on the gasket by the processor to keep it in
place before screwing in the back panel.
23.
Replace the two lock nuts on the opposite side of the Mixed Media module.
Tighten these nuts to 0.9 N·m (7.97 in-lb).
Summary of Contents for PRISM MPI-UP PHY-12G
Page 12: ......
