PRISM Field Upgrade Kit Instructions
ix
General Safety Product Specific Statements
Use the product only as specified. Review the following safety precautions to
avoid injury and prevent damage to this product or any products connected to it.
Carefully read all instructions. Retain these instructions for future reference.
Comply with local and national safety codes.
For correct and safe operation of the product, it is essential that you follow
generally accepted safety procedures in addition to the safety precautions specified
in this manual. The product is designed to be used by trained personnel only.
Only qualified personnel who are aware of the hazards involved should remove
the cover for repair, maintenance, or adjustment.
Before use, always check the product with a known source to be sure it is
operating correctly.
This product is not intended for detection of hazardous voltages.
Use personal protective equipment to prevent shock and arc blast injury where
hazardous live conductors are exposed.
When incorporating this equipment into a system, the safety of that system is the
responsibility of the assembler of the system.
WARNING.
Dangerous voltages may be present. To prevent electrical shock,
disconnect the power cord from the unit before starting the upgrade procedure.
Failure to do so could cause serious injury or death. This product does not provide
the AC Mains power switch.
CAUTION.
Many components within the instrument are susceptible to static-static
discharge damage. To prevent static discharge damage, service the product only in a
static-free environment. Observe standard handling precautions for static-sensitive
devices while installing this kit. Always wear a grounded wrist strap, grounded foot
strap, and static resistant apparel while installing this kit.
NOTE.
The GPIO board is only supported by the rear panel plate. When removing
the rear panel plate be aware that the GPIO board is now loose and take steps to
support it.
Summary of Contents for PRISM MPI-UP PHY-12G
Page 12: ......
