PRISM Field Upgrade Kit Instructions
19
24.
Hold GPIO board in the rear panel plate and secure it in place with two jack
screws on either side of the D connector. Tighten the two jack screws to
0.6 N·m (5.31 in-lb).
Figure 26: Secure the GPIO board on the rear plate panel
25.
Replace the rear panel plate as shown in the following figure. Tighten the four
rear panel plate screws to 0.9 N·m (7.97 in-lb).
NOTE.
Lift up top edge of back panel to fit the rear panel plate into place.
Figure 27: Install the rear plate panel
Summary of Contents for PRISM MPI-UP PHY-12G
Page 12: ......
