16
PRISM Field Upgrade Kit Instructions
14.
Turn the board over and use a TORX-driver with a T-10 TORX tip to remove
the screw from the mezzanine board.
15.
Remove the mezzanine board from the connector and set it aside.
Figure 21: Remove the mezzanine board
16.
Refer to the following figure and install the screw from the kit (part
number 211-1117-XX) and the spacer post (part number
129-1889-XX) into the hole closest to second connector using the following
method:
a.
Insert the screw from the bottom of the board and use a finger to hold
it in place.
b.
Install the spacer post over the screen on the board, while keeping a finger
on head of the screw; tighten the spacer post until tight.
Figure 22: Install the spacer on the board
Summary of Contents for PRISM MPI-UP PHY-12G
Page 12: ......
