PRISM Field Upgrade Kit Instructions
15
11.
Remove the GPIO board from the Mixed Media module using the following
steps:
a.
Disconnect the GPIO ribbon cable.
b.
Disconnect the USB and remove the board.
Figure 19: Remove the GPIO board
12.
Use a TORX-driver with a T-10 TORX tip to remove the four screws on the
corners of the Mixed Media board.
13.
Slide the Mixed Media board out from between the grinches as shown in
the following figure.
Figure 20: Remove the Mixed Media board from the bracket
Summary of Contents for PRISM MPI-UP PHY-12G
Page 12: ......
