Teledyne T3PS13206P, User Manual, Page: 7 / 197

SAFETY INSTRUCTIONS
7
into the power supply.

Do not use chemicals containing harsh products
such as benzene, toluene, xylene, and acetone.
Operation
Environment

Location: Indoor, no direct sunlight, dust free,
almost non-conductive pollution (Note below)

Relative Humidity: < 80%

Altitude: < 2000m

Temperature: 0°C to 40°C
(Pollution Degree) EN 61010-1:2010 specifies pollution degrees
and their requirements as follows. The T3PSX3200Pseries falls
under degree 2.
Pollution refers to “addition of foreign matter, solid, liquid, or
gaseous (ionized gases), that may produce a reduction of
dielectric strength or surface resistivity”.

Pollution degree 1: No pollution or only dry, non-
conductive pollution occurs. The pollution has no influence.

Pollution degree 2: Normally only non-conductive pollution
occurs. Occasionally, however, a temporary conductivity
caused by condensation must be expected.

Pollution degree 3: Conductive pollution occurs, or dry,
non-conductive pollution occurs which becomes conductive
due to condensation which is expected. In such conditions,
equipment is normally protected against exposure to direct
sunlight, precipitation, and full wind pressure, but neither
temperature nor humidity is controlled.
Storage
environment

Location: Indoor

Relative Humidity: < 70%

Temperature: -10°C to 70°C
Checking the AC
Voltage
CAUTION
Before the power is turned on,
confirm that the input power
supply meets the following
conditions:
100V/120V/220V/230V ±10%
，
50/60Hz
AC SELECTOR
220V 230V 120V 100V