Teledyne Princeton Instruments PI-MAX 3, System Manual

Page: 201 / 250

Appendix A Technical Specifications 201
Outputs:
• READY:
TTL signal. Represents camera status. It changes state when ready just
before the exposure.
• Gig-E:
Gigabit Ethernet connector.
• LOGIC OUT:
0 to +3.3V programmable logic level output (TTL-compatible).
The output can be programmed via software as:
— ACQUIRING;
— IMAGE SHIFT;
— LOGIC 1;
— READ OUT;
— SHUTTER;
— WAIT FOR TRIGGER.
The output can also be inverted through software.
REFERENCES:
Refer to Section 7.12, Logic Out Control , on page 87 for
complete information about these signals.
• AUX Out:
DC-coupled programmable delay trigger output to synchronize external
devices with PI-MAX3.
The delay is from T0: 0.01 ns - 1.0 s.
• Monitor: TTL signal to monitor actual gate timing
A.1.1 AUX I/O Connector Pinout
Figure A-2 illustrates a typical AUX I/O cable. Refer to Table A-2 for BNC connector
usage and identification.
Figure A-2: Typical AUX I/O Cable
Table A-2: AUX I/O Cable Leads
Name Color Pin Center Pin Return
T0 OUT Red Pin 1 Pin 3
PRE-TRIG IN Green Pin 2 Pin 6
SyncMASTER1 Blue Pin 7 Pin 18
GP INPUT 0 Gray Pin 8 Pin 20
SyncMASTER2 Black Pin 23 Pin 25
4
4
11-
0129
_00
0
7