Teledyne Princeton Instruments PI-MAX 3, System Manual

Page: 134 / 250

134 PI-MAX
®
3 System Manual Issue 2
Figure 9-5 illustrates the timing diagram for this experiment.
Figure 9-5: Timing Diagram: Swept Gate Experiment [Fixed Width, Variable Delay]
Perform the following procedure to configure this experiment:
NOTE:
Because this procedure uses the experiment as its Master
Clock, refer to
Figure 9-4 and Figure 9-5 for connection
information.
1. Turn on the equipment and launch LightField.
2. Open the Sensor expander and click on Sensor Cleaning.
The Sensor Cleaning fly-out panel is displayed similar to that illustrated in
Figure 9-6 which shows the setup for a PI-MAX3: 1024i camera.
Figure 9-6: Typical Sensor Cleaning Fly-out Panel
a. If one or more orange reset buttons are shown on the fly-out pane, click on
them to reset to the default values.
b. Configure the Sensor Temperature by entering the desired Temperature
Setpoint.
Trigger In
*
* Level changes for T0 depend on the pulse sequence(s) defined by the user.
~12 ns
Delay is programmable. Aux Out
4
4
11-
01
29
_
005
4
4
4
11
-01
29
_0080