52
215861 REV C
Installation, Outdoor HPO PowerMAX System
3.1.13.5 SSPA Module M&C Cables (L213827-1, -2)
Communication for monitor and control purposes between the SSPA Controllers and
each of the connected amplifiers is established through the Monitor & Control Cables.
These cables connect to Port J4 of the SSPA Controller, and to Port J4 of each SSPA
in the controller’s array of amplifiers. A label is affixed near each connector that de-
scribes the port to which it should be attached.
The cable used is part number L213827-1 for the SSPA modules connected to Control-
ler 1 (either system), and part number L213827-2 for the SSPA modules connected to
Controller 2 (either system). See
Figure 3-19
.
3.1.13.6 Mute Signal Jumper Cable (L215836-1)
The mute signal jumper cable is part number L215836-1. This cable connects to the
sure seal connector on the SSPA Module M&C Cables, L213827-1 and L213827-2.
See
Figure 3-20
. A label is affixed near each connector that describes the cable
connection to which it should be attached.
Figure 3-19: SSPA Module M&C Cable, L213827-1/-2
Figure 3-20: Mute Signal Jumper Cable, L215836-1
