Installation, Outdoor HPO PowerMAX System
215861 REV C
9
2.0 Introduction
This section describes the unpacking, inspection and installation procedures the user
should follow to set up a 8-way C-Band High Power Outdoor PowerMAX System.
2.1 Installation
The system was shipped from the factory as intact as possible, but some assembly is
required to complete the installation. The system includes the following components:
(2) Uni-Strut Frames;
(2) Waveguide/Combiner Assemblies;
(1) Uni-Strut Support, 63-inch;
(2) Uni-Strut Supports, 18-inch;
(1) Magic Tee Assembly and Termination;
(8) High Power Outdoor SSPA Modules;
(2) Outdoor SSPA Controller Assemblies;
(1) RF Distribution Box Assembly;
(1) Optional AC Distribution Box Assembly;
(1) Optional Maintenance Switch Controller;
(1) Optional Maintenance Switch and Termination
(1) Optional Outdoor Ethernet Switch (attached to Controller Assembly);
Coaxial cables and COMS cables.
See
Figure 2-1
on the following page.
When securing all hardware during installation, refer to
Appendix A
for hardware
torque values.
Section 2: Installation, 8-Way System
