24
215861 REV C
Installation, Outdoor HPO PowerMAX System
2.1.8 Install RF Distribution Box
The RF Distribution Box was shipped with its mounting bracket attached to the unit.
The hardware used to attach the supports was shipped in place in the uni-strut frame.
Secure the mounting brackets between the two frames on the RF Input end of the sys-
tem, as shown in
Figure 2-22
. Tighten hardware securely.
Connect the green/yellow striped ground wire attached to the 18 inch segment of uni-
strut (installed in
Section 2.1.2.2
) to the earth ground stud on the RF Distribution Box.
Figure 2-22: Install RF Distribution Box
