Command Descriptions
2–120
TDS Family Oscilloscope Programmer Manual
!!"
leaves acquired data points on the display for a period of time
specified by DISplay:PERSistence.
" !
connects adjacent data points. Old points are immediately replaced by
new ones.
causes the display to show acquired (non-interpolated) samples
with brighter or different colored dots than the rest of the waveform.
sets the display to indefinitely accumulate data points on the screen.
might return
indicating that the display shows individual waveform data
points.
DISplay:TRIGBar
Controls the display of the trigger bar indicator/s. The bar indicates where the
trigger will occur, in voltage.
The digitizing oscilloscope will only display the bar if the trigger source is also
displayed. If both a main and a delayed trigger are displayed, then two bars will
appear. One will accompany each source. If a logic trigger is selected, then
multiple bars may appear. If a runt pulse trigger is selected, then two bars may
appear. One will show the upper threshold and one the lower threshold.
Display
# $ % " % &
#
"
#
removes the trigger bar indicator from the display.
"
displays a short arrow at the right side of the graticule for each displayed
trigger signal.
Examples
Group
Syntax
Arguments
Summary of Contents for TDS 410A
