TDS Family Oscilloscope Programmer Manual
D–1
Appendix D: Factory Initialization Settings
The factory initialization settings provide you a known state for the digitizing
oscilloscope.
Factory initialization sets values as shown in Table D–1.
Table D–1: Factory Initialization Settings
Control
Changed by Factory Init to
Acquire mode
Sample
Acquire repetitive signal
(TDS 4XXA, 5XXA, & 7XXA)
ON (Enable ET)
Acquire stop after
RUN/STOP button only
Acquire # of averages
16
Acquire # of envelopes
10
Channel selection
Channel 1 on, all others off
Cursor H Bar 1 position
10% of graticule height
(–3.2 divs from the center)
Cursor H Bar 2 position
90% of the graticule height
(+3.2 divs from the center)
Cursor V Bar 1 position
10% of the record length
Cursor V Bar 2 position
90% of the record length
Cursor amplitude units
Base
Cursor function
Off
Cursor mode
Independent
Cursor time units
Seconds
Date and time
No change
Delay events,
triggerable after main
TDS 4XXA: 1
TDS 5XXA, 6XXA, & 7XXA: 2
Delay time,
delayed runs after main
TDS 4XXA: 10 ns
TDS 5XXA, 6XXA, & 7XXA: 16 ns
Delay time,
delayed triggerable after main
TDS 4XXA: 60 ns
TDS 5XXA, 6XXA, & 7XXA: 16 ns
Delay trigger average #
16
Delay trigger envelope #
10
Delayed, delay by ...
Delay by Time
Summary of Contents for TDS 410A
