Tektronix RSA3300A, Service Manual

Page: 74 / 284

Performance Tests
4- 18
RSA3303A & RSA3308A Service Manual
4. Perform the tests in the baseband and RF1 band:
Press the
BB+RF1
side key to perform the tests.
5.
Check the test results:
Check the pass/fail results displayed on the lower left of the screen
(see Figure 4--7 on page 4--16).
If the instrument fails any tests, go to When the Auto Tests Fail on
page 4--19.
STOP
. Steps 6 through 8 are the tests in the RF2 and RF3 bands for RSA3308A
only. For RSA3303A, skip to step 9.
6.
Change the signal generator:
a.
Disconnect the N--N cable from the signal generator (Item 1) output.
b.
Connect the N--N cable to the signal generator (Item 2) output.
c. Set the GPIB address of the generator:
H
Press the Config... side key.
H
Press the SG Type side key to select the manufacturer of the
generator (Item 2) for the GPIB command system: HP or Anritsu.
H
Press the GPIB Address side key and set the generator address.
H
Press the Cancel--Back (top) side key.
7. Perform the tests in the RF2 and RF3 bands:
Press the
RF2+RF3
side key to perform the tests.
8.
Check the test results:
Check the pass/fail results displayed on the lower left of the screen
(see Figure 4--7 on page 4--16).
If the instrument fails any tests, go to When the Auto Tests Fail on
page 4--19.
9.
Disconnect the test equipment:
a. Disconnect the N-N cable from the analyzer input.
b. Turn off the analyzer and generators.
c. Disconnect the GPIB cables from all the ports.