Tektronix RSA3300A, Service Manual

Page: 73 / 284

Performance Tests
RSA3303A & RSA3308A Service Manual
4- 17
1. Prepare for the test:
Hook up the equipment as shown in the following figure.
50
Ω
N-N coaxial cable
Output
RSA3303A/RSA3308A
10 dB attenuator
GPIB cable
Signal generator (Item 1) Signal generator (Item 2)
GPIB cable
a. Power off the analyzer and the signal generators.
b. Connect the analyzer and the generators with GPIB cables.
c. Connect the analyzer INPUT through a 10 dB attenuator followed by a
50 Ω N-N coaxial cable to the generator (Item 1) output.
d. Power on the analyzer and the generators.
e. Set the GPIB address of the generators, ranging from 1 to 30.
Assign a unique address to each instrument.
f.
Insert the SG flatness floppy/spurious disk (Item 17) for the generator
(Item 2) to the floppy disk drive of the analyzer.
2. Perform the self calibration: Press CAL > Calibrate All .
3.
Enter the PV menu:
a.
Press
Service...
>
Password
in the CAL menu.
b. Enter 270833 and then press ENTER using the numeric keypad.
c. Press the PV side key.
d. Set the GPIB address of the generator:
H
Press the Config... side key.
H
Press the SG Type side key to select the manufacturer of the
generator (Item 1) for the GPIB command system: HP or Anritsu.
H
Press the SG Address side key and set the generator address.
H
Press the Cancel--Back (top) side key.