Tektronix RSA3300A, Service Manual

Page: 136 / 284

Adjustment Procedures
5- 26
RSA3303A & RSA3308A Service Manual
e. Set the GPIB address of the generators, ranging from 1 to 30.
f. Insert the SG flatness/spurious floppy disk (Item 16) for the generator
(Item 1) to the floppy disk drive of the analyzer.
2. Enter the calibration menu:
a. Press Service... > Password in the CAL menu.
b. Enter 270833 and then press ENTER using the numeric keypad.
c. Press the CAL side key.
d. Set the GPIB address of the generator:
H
Press the
Config...
side key.
H
Press the
SG Type
side key to select the manufacturer of the
generator (Item 1) for the GPIB command system: HP or Anritsu.
H
Press the SG Address side key and set the generator address.
H
Press the Cancel--Back (top) side key.
3.
Perform the calibration in the baseband and RF1 band:
Press the BB+RF1 side key to run the calibration.
STOP
. Steps 4 and 5 perform calibration in the RF2 and RF3 bands for
RSA3308A only. For RSA3303A, skip to step 6.
4. Change the signal generator:
a. Disconnect the N--N cable from the signal generator (Item 1) output.
b. Connect the N--N cable to the signal generator (Item 2) output.
c.
Change the SG flatness/spurious floppy disk (Item 16) with the one for
the generator (Item 2).
d. Set the GPIB address of the generator:
H
Press the Config... side key.
H
Press the SG Type side key to select the manufacturer of the
generator (Item 2) for the GPIB command system: HP or Anritsu.
H
Press the SG Address side key and set the generator address.
H
Press the Cancel--Back (top) side key.