Tektronix RSA3300A, Service Manual

Page: 71 / 284

Performance Tests
RSA3303A & RSA3308A Service Manual
4- 15
a. Power off the analyzer and the generator.
b. Connect the analyzer and the generator with a GPIB cable.
c. Connect the analyzer INPUT through a 10 dB attenuator followed by a
50
Ω
N-N coaxial cable to the generator output.
d. Power on the analyzer and the generator.
e. Set the GPIB address of the generator, ranging from 1 to 30.
f. Insert the SG flatness/spurious floppy disk (Item 17) for the generator to
the floppy disk drive of the analyzer.
2.
Perform the self calibration:
Press CAL > Calibrate All .
3. Enter the PV menu:
a. Press Service... > Password in the CAL menu.
b. Enter 270833 and then press ENTER using the numeric keypad.
c. Press the PV side key.
d.
Set the GPIB address of the generator:
H
Press the
Config...
side key.
H
Press the SG Type side key to select the manufacturer of the
generator for the GPIB command system: HP or Anritsu.
H
Press the
SG Address
side key and set the generator address.
H
Press the Cancel--Back side key.
4.
Perform the tests in all bands:
Press the All Band side key to perform the tests.
NOTE
. You can select the test items and bands as described in
Service PV Menu
on page 4--12.
5. Check the test results:
Check the Pass/Fail results displayed on the lower left of the screen
(see Figure 4--7).
If any tests fail, go to When the Auto Tests Fail on page 4--19.