Tektronix RSA3300A, Service Manual

Page: 172 / 284

Removal and Installation Procedures
6- 26
RSA3303A & RSA3308A Service Manual
4. Remove the handle caps:
a. Insert the retaining ring pliers (Item 13) into the opening created in the
handle cap when you removed the handle.
b. While using the pliers to expand the handle cap outward, grasp it and
snap it away from the cabinet.
c. Repeat procedure to remove the remaining cap as needed.
d.
To reinstall, push the cap(s) back on.
5. Remove the flip stand:
a. Grasp the flip stand by both sides near where it joins each flip stand foot.
b. Compress the flip stand until the flip stand ends clear the flip stand feet.
c. To reinstall, compress the flip stand and insert it into the flip stand feet.
6. Remove the foot:
a. Remove the cabinet (refer to Cabinet on page 6--23).
b.
Working from inside the cabinet, push the two retainers to release the
foot you wish to remove and lift it away from the outside of the cabinet.
c. Remove as many of the feet as needed.
d. To reinstall feet, reinsert the two retainers into their slots in the cabinet
and snap into place.
7. Reinstallation: If any flip stand feet were removed, reinstall as directed in
step 6c; then refer to the Cabinet procedure on page 6--23 to reinstall the
cabinet. Reverse steps 3 and 5, reversing each step, to reinstall the flip stand,
then the handle caps (if removed), then the handle.