Tektronix RSA3300A, Service Manual

Page: 169 / 284

Removal and Installation Procedures
RSA3303A & RSA3308A Service Manual
6- 23
Procedures for External Modules
Read the
Access Procedure
on page 6--22 before proceeding. The procedures are
presented in the following order:
H
Line cord
H
Cabinet
H
Front cushion
H
Cabinet modules
1. Orient the analyzer: Set the analyzer so its bottom is down on the work
surface and its rear is facing you.
2. Remove the line cord: Remove the line cord from the rear cover. See
Figure 6--13.
3.
Reinstallation: Reverse step 2 to reinstall the line cord.
1.
Assemble equipment:
Obtain a #2 Phillips screwdriver (Items 1 and 3).
2. Orient the analyzer: Set the analyzer so its bottom is down on the work
surface and the rear panel is facing you.
3.
Remove the cabinet:
See Figure 6--13.
a. Remove the one screw securing the rear foot over the cabinet to the rear
panel at each corner.
b.
Remove the center two screws securing the cabinet to the rear panel.
c. Slide the cabinet backward. As you remove the cabinet, take care not to
bind or snag it on the analyzer’s internal cabling.
4. Reinstallation: Reverse step 3 to reinstall the cabinet.
Line Cord
Cabinet