Display Waveform Data
Quick Tips
Using Probes with the TekProbe II and TekVPI Interfaces.
When you attach a probe with the TekProbe II or the TekVPI
interface, the oscilloscope sets the channel sensitivity, coupling, and termination resistance automatically to match the probe
requirements. Tek Probe II probes require use of the TPA-BNC Adapter.
The Difference Between Vertical Position and Offset.
Vertical position is a display function. Adjust the vertical position to
place the waveforms where you want to see them. The waveform baseline locations track adjustments made to their positions.
When you adjust vertical offset, you see a similar effect, but it is actually quite different. Vertical offset is applied before the
oscilloscope preampli
fi
er and can be used to increase the effective dynamic range of the inputs. For example, you can use
vertical offset to look at small variations in a large DC voltage. Set the vertical offset to match the nominal DC voltage and
the signal appears in the center of the screen.
50
Ω
Protection.
If you select 50
Ω
termination, the maximum vertical scale factor is limited to 1 V/div, except that with a 10X
probe the scale factor is 10 V. If you apply excessive input voltage, the oscilloscope automatically switches to 1 M
Ω
termination
to protect the internal 50
Ω
termination. For more details, refer to the speci
fi
cations in the
Tektronix 4000 Series Oscilloscopes
Technical Reference
.
160
Tektronix 4000 Series Oscilloscopes User Manual
Summary of Contents for 4000 Series
