Taylor-Dunn C0-425-36, Operation, Troubleshooting And Replacement Parts Manualooting And Replacement Parts Manual

Page: 29 / 246

Safety Rules Page 11
SAFETY RULES AND OPERATING INSTRUCTIONS
Run Time Hours icon
Fault Code Description Corrective action
01004 Discharged battery or defective wiring. Charge the battery. If the battery is
good, check wiring to the controller.
01005 Speed control overheated. Allow the controller to cool off. May be
the result of an overloaded vehicle or an
obstruction to the controller heat sink.
01008 Optional speed encoder or speed encoder
wiring defective Repair as required
02000 Start up switches not operated in the correct
order or a defective switch. Reset switches and start again.
02001 Defective wiring Refer to troubleshooting
04003 Start up switches not operated in the correct
order or a defective switch. Reset switches and start again.
04004 Both the forward and reverse directions are
selected at the same time Check the forward/ switch and wiring
for shorts.
04005 Start up switches not operated in the correct
order or a defective switch. Reset switches and start again.
04006 Accelerator pedal depressed before the seat
interlock switch is closed Recycle start up switches and try again.
Possible defective seat switch.
04007 - Defective wiring
04009 Discharged battery or defective wiring. Charge the battery. If the battery is
good, check wiring to the controller.
04010 Battery voltage too high Incorrect battery installed.
04011 Personality fault Reprogram the controller
04012 Personality fault Reprogram the controller
04013 Defective wiring or batteries Refer to troubleshooting
05000 Line contactor coil or wiring shorted Replace contactor or repair wiring
05006 MOSFET shorted Refer to troubleshooting
05008 Line contactor welded contacts or wiring
shorted Replace contactor or repair wiring
05009 MOSFET shorted Refer to troubleshooting
05046 Line contactor contacts open or defective
wiring Replace contactor or repair wiring.
Could also be result of open circuit
breaker
Run Time Hours: After the initial 5-seconds, the Run
Time Hours will be displayed as indicated by the Run
Time Hours Indicator located at the left of the display.
The icon represents a motor symbol with a “T” in the
center.
Speed controller status: The display will indicate a fault
code whenever the control system logic detects a problem
with the control system. A fault code is being displayed
whenever the Fault Code Indicator (the letter ‘F’) is visible
at the left of the numeric display. Refer to the table below
for a list of fault codes and their descriptions.