Taylor-Dunn C0-425-36, Operation, Troubleshooting And Replacement Parts Manualooting And Replacement Parts Manual

Page: 68 / 246

Maintenance, Service, and Repair
Steering Page 14
Replacing the Drag Link
The Drag Link is the linkage that connects the steering gear pitman arm to the steering knuckle. Refer
to the illustration on the following page.
Always use a lifting strap, hoist, and jack stands, of adequate capacity
to lift and support the vehicle. Failure to use lifting and support devices
of rated load capacity may result in severe bodily injury.
Pitman Arm
Drag Link
Steering Knuckle
Typical Drag Link
T
A Y
L OR - D U N
N
T
h
e
B
e
st
W
ay
To
Go About
Yo
ur
Bu
si
n
e
s
s
R
6. Raise the front of the vehicle and support with jack stands.
7. Remove the ball joints or rod ends from the steering
knuckle and pitman arm.
NOTE: Refer to the
Replacing the Ball
Joints
section for information
regarding the removal of the ball joints
or rod ends.
8. Remove the drag link as an assembly.
9. Install in reverse order.
10. Realign the front wheels.
NOTE: Refer to the
Steering
section for
information regarding realignment of
the front wheels.
11. Lower the vehicle.
12. Reconnect the main battery connector.
13. Remove the blocks from behind the wheels.
14. Release the park brake and test drive the vehicle.
1. Make sure the key-switch is in the “OFF” position, then remove
the key.
2. Place the forward-reverse switch in the center “OFF” position.
3. Set the park brake.
4. Place blocks under the rear wheels to prevent vehicle movement.
5. Unplug the main battery connector.