Taylor-Dunn C0-425-36, Operation, Troubleshooting And Replacement Parts Manualooting And Replacement Parts Manual

Page: 152 / 246

Maintenance, Service, and Repair
Batteries Page 10
If the batteries are removed from the vehicle, do not place them
directly on the ground, concrete or solid metal surface. It is
recommended to store them on a wooden pallet or equivalent. Storing
on the ground, concrete or solid metal surface will cause the batteries
to discharge and may result in premature failure of the batteries.
e g a r o t S
e r u t a r e p m e T
) F (
l a v r e t n I g n i g r a h C
) s h t n o m (
0 6 r e v O 1
0 6 d n a 0 4 n e e w t e B 2
0 4 w o l e B 6
Battery electrolyte will stain and corrode most surfaces. Immediately
and thoroughly clean any surface outside of the battery that the
battery electrolyte comes in contact with. Failure to clean may result
in property damage.
STORAGE AND RETURNING TO SERVICE
Storage
Thoroughly clean the batteries and battery compartment. Refer to
Cleaning
in this section for information
regarding cleaning the batteries.
Check the electrolyte level and charge the batteries. Refer to
Watering
in this section for information
regarding checking the electrolyte level.
Store the vehicle or batteries in a cool, dry, well ventilated area.
If storing for more than one month, the batteries should be charged as follows:
6. Fill all battery cells with electrolyte to the proper
level.
7. Thoroughly clean any spilled electrolyte from the
batteries or the ground. Refer to
Cleaning the
Batteries
for information on cleaning the
batteries.
8. Reconnect the battery cables, connect the batteries
to the charger and allow the charger to complete
one charging cycle.
9. Remove the blocks from the wheels and test drive.
The batteries are now ready to be put into service.