Taylor-Dunn C0-425-36, Operation, Troubleshooting And Replacement Parts Manualooting And Replacement Parts Manual

Page: 149 / 246

Maintenance, Service, and Repair
Batteries Page 7
Battery electrolyte will stain and corrode most surfaces. Immediately
and thoroughly clean any surface outside of the battery that the
battery electrolyte comes in contact with. Failure to clean may result
in property damage.
1. Make sure the key-switch is in the “OFF” position, then remove
the key.
2. Place the forward-reverse switch in the center “OFF” position.
3. Set the park brake.
4. Place blocks under the front wheels to prevent vehicle movement.
5. Disconnect the main positive and negative cables at the batteries.
Explosive mixtures of Hydrogen gas are present within battery cells
at all times. Do not work with or charge battery in an area where
open flames (including gas furnace or water heater pilots), sparks,
cigarettes, or any other sources of combustion are present. Always
provide ample ventilation in rooms where batteries are being charged.
Failure to do so may result in severe property damage and or serious
A battery is a live electrical source. It cannot be disconnected or
neutralized. Do not drop any tool or conductive object onto the battery.
A conductive object that comes in contact with the battery terminals
will initiate a short circuit of the battery. This could cause the battery
to explode resulting in property damage and/or bodily injury.
Battery electrolyte is poisonous and dangerous. It contains sulfuric
acid. Avoid contact with skin eyes or clothing. Wear rubber gloves
and safety glasses while servicing batteries. DO NOT INGEST! This
may result in serious bodily injury.
REPLACING (6-VOLT BATTERIES ONLY)
NOTE: If the batteries are over one year old, it is recommended to replace
them as a set.
6. Thoroughly clean the batteries and battery compartment. Refer to
Cleaning
in this section
for information regarding cleaning the batteries.