Quick Start Guide
AUTOLOADER LTO3 – User Reference Manual Rev. 1.01
TANDBERG DATA
Page 1 2 of 79
5 Quick Start Guide
Defaults
NOTE:
The following defaults have been set at the factory.
LDR SCSI ID
0
DRV SCSI ID
5
Operating Mode
Sequential
Figure 1
AC line cord, SCSI terminator
1. Install AC line cord, first to autoloader (receptacle 2), then to AC outlet.
2. Install SCSI terminator on autoloader (receptacle 1).
Figure 2
Power switch
3. Use the eraser end of a pencil or something similar to press the left side of the power switch. The
autoloader powers up.
Install data cartridges in slots 1-8 :
4. Place cartridge in the cartridge access port.
