Installation and Setup
Installing the
Optional Bar Code Reader (BCR)
AUTOLOADER LTO3 – User Reference Manual Rev. 1.01
TANDBERG DATA
Page 2 2 of 79
7.2.3 Mounting Instructions:
CAUTION
Electro static discharge!
Destruction of the ESD sensitive components.
Please touch unit cover or rear panel before installing the RMU.
The barcode reader is to be mounted on the rear side of the autoloader.
1.
Power down the autoloader.
2. Disconnect the power cord from the outlet. Remove the SCSI cable(s) and power cord from the
rear panel of the autoloader.
3.
Remove the cover plate from the rear panel (see Figure 10). Save the screws! Save and store the
cover plate; you may use this plate later after removing the barcode reader.
Figure 10
Location of the cover plate for the BCR rail
4.
Orient the barcode reader before the slot. There is only one correct orientation. Check whether the
holes align.
5. Connect the cable to the barcode controller outlet.
6. Attach the barcode reader with the screws (see Figure 11).
Figure 11
Connecting of the BCR
7.
Reconnect the SCSI cables and power cord to the autoloader.
8. Power on the autoloader.
Formatiert:
Nummerierung und
Aufzählungszeichen
Formatiert:
Nummerierung und
Aufzählungszeichen
Formatiert:
Nummerierung und
Aufzählungszeichen
Formatiert:
Nummerierung und
Aufzählungszeichen
