Tandberg Data Magnum 224, Product Manual, Page: 67 / 278

A
UGUST
2007 M
AGNUM
224, S
TORAGE
L
IBRARY
T24,
OR
S
TORAGE
L
OADER
2U
49
S
ETTING
C
ONFIGURATION
O
PTIONS
C
HANGING THE
SCSI ID
S
Each device on a SCSI bus must have a unique SCSI ID so that it can be
identified by the host computer. You can use the default IDs for the tape
drive(s) or change them if they conflict with other devices on the SCSI bus.
Notes: The library communicates with the host through the SCSI interface of the
tape drive(s) via the ADI serial interface. The SCSI interface as seen by the
host is the SCSI interface of the tape drive.
See the tape drive Product Manual for tape drive information.
See Automation/Drive Interface - Command (ADC) for ADI information.
If you change the tape drive’s SCSI ID after the library has been in
operation, you may need to reboot your host computer so that it
recognizes the new ID.
To change the tape drive’s SCSI ID:
1. 1. 1. 1. At the Home screen, press Drive .
If necessary, enter the operator panel password (see page 75 ).
2. 2. 2. 2. Press until the selection arrow ( ) points to Interface .
3. 3. 3. 3. Press Select .
Drive
Drive ID
Interface
Drive Configuration
Library SCSI Bridge
Select Back
Interface
Source Drive
01 02
Address: 0051 (element address)
Drive 1: (empty)
Select Back
– +