Tandberg Data Magnum 224, Product Manual, Page: 240 / 278

222
P
RODUCT
M
ANUAL
1017472
A
PPENDIX
B—I
NTERFACE
S
PECIFICATION
E
THERNET
S
PECIFICATIONS
This section provides specifications for the library’s Ethernet interface,
including information about the following:
General Ethernet information
Cable requirements
Ethernet port pin assignments
G
ENERAL
E
THERNET
I
NFORMATION
The Ethernet port allows connection to a 10/100Base T Ethernet network. You
can use the Ethernet connection to perform the following activities:
Monitor library operations using the built-in Remote Management utility
(see
Chapter 4 )
Upload diagnostic information from the library and tape drives using FTP
(see
“Creating a Diagnostic Listing via FTP” on page 185 )
Upgrade the library’s firmware using FTP (see “Upgrading Library
Firmware via FTP” on page 185 )
E
THERNET
C
ABLE
R
EQUIREMENTS
The Ethernet port connector is a pin-through-hole RJ-45 shielded connector.
To connect to the Ethernet port, use the shielded Category 5 (10/100BaseT
connection) data-grade cable included with the library or a similar Category 5
cable that is compliant with EIA/TIA 568.
E
THERNET
P
ORT
P
IN
A
SSIGNMENTS
Table B-5 shows the Ethernet port’s pin assignments and functions.
Table B-5
Ethernet port pin assignments and functions
Pin number Function
1 TD+
2 TD–
3 RD+
4 Not used
5 Not used
6 RD–
7 Not used
8 Not used