Tandberg Data Magnum 224, Product Manual, Page: 191 / 278

A
UGUST
2007 M
AGNUM
224, S
TORAGE
L
IBRARY
T24,
OR
S
TORAGE
L
OADER
2U
173
R
ECONFIGURING THE
L
IBRARY AND
R
ESUMING
O
PERATION
Note: The library lists “no drive” only if there is no room for more tape
drives. For example, in the above screen, the library has one half
height tape drives. The two tape drive number is for two half height
tape drives.
4.
4. 4.
4.
Press Modify . Press or until the selection arrow ( ) points to the
desired configuration. Press Select .
Notes: This menu option requires input for all of the tape drives installed in
the library. If you press “Back” before configuring all the tape drives,
the configuration selection will not change.
5. 5. 5. 5. Press OK .
6. 6. 6. 6. Repeat the process for each tape drive installed.
7. 7. 7. 7. Press Back (as needed) to return to the Home screen.
R
ESUMING
O
PERATION
1. 1. 1. 1. Power the library off (Press the 0 on the back of the unit—after setting the
new tape drive configuration).
2. 2. 2. 2. Connect the interface cables.
a. a. a. a. Connect the Fibre Channel cable (or cables if you installed more than one
Fibre Channel tape drive).
or...
b. b. b. b. Connect the SCSI cable (or cables if you installed more than one tape
drive) and a terminator (if needed).
Select Drive 1
HP LTO HalfHigh
TANDBERG LTO HH
IBM LTO FullHigh
Select Back
! ! ! !
Important
LTO-2, LTO-3, and LTO-4 SCSI tape drives require an Ultra 3
or LVD 160 terminator to function properly on the SCSI bus.
An inadequate terminator will result in various SCSI bus issues,
including bus hangs and Read/Write failures. See
“Tape Drive
Fails with Sporadic Errors” on page 197 .