Tandberg Data Magnum 224, Product Manual, Page: 192 / 278

174
P
RODUCT
M
ANUAL
1017472
C
HAPTER
7—M
AINTENANCE
Notes: You must install a terminator on the device at the physical end of the
SCSI bus. If one of the tape drives in the library terminates the SCSI
bus, you must install the required terminator on one of the tape
drive’s SCSI connectors.
If there are additional devices on the SCSI bus, ensure that only the
device at the physical end of the bus is terminated.
The library communicates with the host through the SCSI interface of
one of the tape drive via the Automation Drive Interface (ADI) serial
interface.
See the tape drive’s
Product Manual for tape drive information.
IBM — www.storage.ibm.com/tape/lto/oem/index.html
Hewlett Packard — www1.hp.com/storage/tapestorage.html
See Automation/Drive Interface for ADI information: www.T10.org
3. 3. 3. 3. Reconnect the power cord and power on the library (press the
I
on the back
of the unit), and then power on the host.
The library is now ready to resume operation. The new tape drive defaults to
the following SCSI IDs:
C
ONFIRMING THE
I
NSTALLATION
You may want to perform a few load and unload operations and back up
several megabytes of data to ensure that the library and the newly installed
tape drive (or tape drives) are communicating correctly.
Tape Drive Configuration SCSI ID
Single half height tape drive 3
Two half height tape drives
Upper tape drive 4
Lower tape drive 3
Full height tape drive 3
! ! ! !
Important
You may need to reconfigure your backup application to
recognize the new tape drive. Refer to your application’s
documentation for instructions.
Use LibTool to
Detect the library
View the library’s cartridge inventory
Move tapes into and out of the tape drive
Use LTOTool to
Detect the tape drive
Perform a Read/Write test