Tandberg Data Magnum 224, Product Manual, Page: 33 / 278

A
UGUST
2007 M
AGNUM
224, S
TORAGE
L
IBRARY
T24,
OR
S
TORAGE
L
OADER
2U
15
A
TTACHING THE
R
AILS TO THE
R
ACK
A
TTACHING THE
R
AILS TO THE
R
ACK
1. 1. 1. 1. Left side rail assembly —Position the left-side rail assembly in the rack so
that the front flange is behind the front screw holes in the rack.
2. 2. 2. 2. Front of rack —Insert an M5 screw ( A ) through one of the front rack screw
holes ( B ) and engage the pem nut in the rail flange ( C ). If your rack has
square mounting holes or the holes are much larger than the screws
provided in the kit, use a washer. Finger-tighten the screw.
Insert an M5 screw ( A ) through a second screw hole ( B ) and engage the
pem nut on the second screw hole in the rail flange ( C ). If necessary, use a
washer. Finger-tighten the screw.
3.
3. 3.
3.
Adjust the length of the rail assembly as necessary to fit the depth of the
rack (
E
).
4. 4. 4. 4. Back of rack —Make sure the rail assembly is level, and then use M5 screws
( A ) to attach the back flange ( D ) of the rail to the inside of the rack, using the
same procedure as step 2. If your rack has square mounting holes or the
holes are much larger than the screws provided in the kit, use a washer.
Finger-tighten the screws.
5. 5. 5. 5. Using a #2 Phillips screwdriver, tighten the screws securing the rails to the
front and back of the rack.
Figure 2-3
Attaching the left-side rail to the rack
Level
M5 screw ( A )
Rack rail
(back)
Front flange ( C )
Rack rail
(front)
Front rack
screw holes (
B )
M5 screw ( A )
Back
flange (
D )
Front of Rack
Back of Rack
Depth of rack ( E )
(black)
(black)