Tandberg Data Magnum 224, Product Manual, Page: 263 / 278

A
UGUST
2007 M
AGNUM
224, S
TORAGE
L
IBRARY
T24,
OR
S
TORAGE
L
OADER
2U
245
T
APE
A
LERT
F
LAGS
Owned by E-Net The library is executing a
command issued from the
Remote Management utility
(see
Chapter 4 ) when a
command is issued from the
operator panel.
Wait until the library has finished its current
operation, and then retry the operation.
Owned by Panel The library is executing a
command issued from
operator panel when a
command is issued from the
Remote Management utility
(see
Chapter 4 ).
Wait until the library has finished its current
operation, and then retry the operation.
Picker Ship-lock The robot could not move
because it may be locked in
place by the shipping lock. Remove the shipping lock (see page 22 ).
POST Failed The library encountered an
error during its power-on
self-test.
1. Reset the library and retry the operation. See
page 134 for reset instructions.
2. If the error persists, contact Technical Support
(see
page iii ) or your service provider.
Power Fan The library has detected that
the power fan is not
operating properly.
1. Power cycle the library.
2. If the error persists, contact Technical Support
or your service provider.
Report Illegal Request The I/E port door is
unlocked. Lock the I/E port door (press it firmly toward the
library) and retry the operation.
When the I/E port door is locked, the lock icon
illuminates solid green ( ).
Reserve Failed The library could not reserve
the USB device resources.
1. Retry the operation.
2. Reset the library and retry the operation. See
page 134 for reset instructions.
If the error persists, contact Technical Support
(see
page iii ) or your service provider.
Reset Will Occur! When the operation
completes, the library will
reset itself as if a
power-cycle had occurred.
ƒ
If the operation has not started, proceed with
the operation only if the reset will not cause a
problem.
ƒ
If the operation is underway, no action is
necessary; the machine will reset itself.
Right Cable The library detected an error
with the right-side cable. Contact Technical Support (see page iii ) or your
service provider.
Robot Empty The robot is unexpectedly
empty
1. Reset the library and retry the operation. See
page 134 for reset instructions.
2. If the error persists, contact Technical Support
(see
page iii ) or your service provider.
Table E-1
Library error messages (continued)
Error Message Description Corrective Action