TAJIMA TFMX-IIC, User Manual

Page: 6 / 268

Contents
Chapter 5 Functions concerning embroidery
1.
To change color.................................................................................................................... 78
1-1. To change color manually (Manual Color Change) ..................................................... 78
2.
To trim thread ....................................................................................................................... 79
2-1. To trim thread manually (Manual Thread Trimming) ................................................... 79
2-2. To trim thread automatically (ATH).............................................................................. 80
2-3. To change thread breakage detecting sensitivity (Thread Detection) ......................... 83
2-4. To trim thread by the number of consecutive jump stitches (Jump Convert) .............. 85
2-5.
To add thread trimming code to the design and trim thread (Data Edit "Insert") ......... 86
2-6.
To change thread trim timing (ATH Start Timing)........................................................ 88
3.
To set the embroidery speed................................................................................................ 89
3-1.
To limit embroidery speed by stitch length (Min. Revolution) ...................................... 89
3-2.
To set embroidery speed within speed limit section (Revolution limit) ........................ 90
3-3.
To decide upper limit value of the maximum speed (Max. Revolution Limit) ............. 91
4.
To stop the machine ............................................................................................................. 92
4-1.
To stop the machine automatically when reaching the set value (Preset Halt) .......... 92
4-2.
To stop the machine before needle bar hits the frame (Software Frame Limit) ......... 93
4-3.
To stop the machine with needle bar stuck in the material (Stop at Lower D.Point) ... 95
4-4.
To stop at Frame Limit (Frame Limit setting)............................................................... 96
5.
To change the direction and the size of the design .............................................................. 98
5-1.
To perform enlargement, rotation, reversion (Data Conversion) ................................. 98
6.
To embroider the same design repeatedly ......................................................................... 100
6-1. To repeat to horizontal and vertical direction (Repeat).............................................. 100
6-2.
To repeat at the same place (A.S. after Auto Data Set) ............................................ 103