TAJIMA TFMX-IIC, User Manual

Page: 76 / 268

Decision of the design start position
62
Chapter 4
5-4. To check if design fits in embroidery space (Trace)
Since the frame moves according to the size of the design, you can check whether the design fits in the
embroidery space or not.
5-4-1. Screen
5-4-2. How to operate
The following is an example of executing Trace.
(1) To open screen
When performing this operation, do not put your hands etc. on the machine table. Moving
frame could injure you.
1
2
3
4
5
6
7
Start point of design
The number in the left figure indicates the orbit of the frame. After
completion of trace, embroidering from that position is possible.
When repeat is set
The machine will trace whole designs after tracing the first design.
When Automatic Offset is set
The machine traces according to the setting.
D1
/Low/High
Needle position
15
1 Trace
Speed of frame travel
Low: Low speed
High: High speed
-: Not to execute
Current needle bar No.
The frame will move on the basis of this needle bar.
CAUTION
!
'
1 Trace
6(7 6(7