TAJIMA TFMX-IIC, User Manual

Page: 232 / 268

218
Countermeasure when the machine stopped
Chapter 9
32A
The machine cannot memorize excitation of X-
axis driver. Turn "OFF/ON" the power.
Check connection of each frame driver motor
and/or sensor wire.
Replace the corresponding frame driver or
frame motor.
32B
The machine cannot memorize excitation of Y-
axis driver.
32C Incompletion of X-axis frame travel Turn "OFF/ON" the power. Or switch from
sleep mode to normal mode. (Each driver
setting will be reset.) When it is not possible to
recover from the trouble, replace the card.
32D Incompletion of Y-axis frame travel
32E
The machine cannot complete X-axis origin
search within the time.
Check setting for embroidery space at software
installation. Check the sensor card.
32F
The machine cannot complete Y-axis origin
search within the time.
331
Abnormal signal of bobbin changer has been
detected.
Operate the bobbin changer manually after
resetting the error, and check/adjust the place
where motion error occurred.
353
Abnormality occurred in up/down color change
driver (Sequin device III only).
Check the card.
354
Sequin motor, color change motor, ATH motor
overcurrent
(Color change motor and ATH motor are
applicable to single-head machine only.)
Turn OFF/ON the power. Check and/or replace
the head card. Decrease rpm.
362 Jump motor overcurrent
382
The needle position signal status during color
change does not change for 1 second and more.
Check the color change motor and power
supply circuit.
Check the potentiometer (needle position
sensor).
383
Needle position was abnormal.
Check setting for the number of needles at
installation of software.
There was no needle position signal during
rotation of the main shaft. Check the potentiometer (needle position
sensor).
387 Color change motor sensor error
Check encoder signal wire of color change
motor.
3A6
ATH movable knife retractable position has
become nonuniform.
Check the position of ATH movable knife.
3A9 Upper thread holding motor overcurrent
Turn OFF/ON the power. Check and/or replace
head card.
No. Stop Factor How to restore