TAJIMA TFMX-IIC, User Manual

Page: 94 / 268

To trim thread
80
Chapter 5
2-2. To trim thread automatically (ATH)
It is the setting to trim thread.
2-2-1. Screen
[a]
To trim thread automatically
YES: To trim
NO: Not to trim thread
[b] Remaining length of upper thread after thread trimming (1 in the
right figure)
When upper thread remains on the fabric, select the value of "-".
If the thread does not link at the start of sewing due to short of
remaining length of upper thread, select the value of "+".
When "N" is displayed, the value differs in each needle bar.
Regarding the setting of needle bar unit, refer to detailed page.( → p.108)
[c] Number of lowering the needle bar by slow operation at start after thread trimming or after data
set
F2
YES
9 ATH
YES/NO
N
-8
Inching after ATH
4
2
Return stitches
NO
1/2/T0/T1/T2/NO
Return Stitch Length
N
A
A/B/C/D
Thread trim length
9
+8
Tie stitches
Tie Stitch Length
N
0.6 2.0 [mm]
0.4 2.0 [mm]
[b]
F2
9 ATH
B
A/B
Hook
To the next page
[c]
[d]
[e]
[f]
[g]
[h]
[a]
1
-8 +8
Short Long
0