TAJIMA TFMX-IIC, User Manual

Page: 110 / 268

To stop the machine
96
Chapter 5
4-4. To stop at Frame Limit (Frame Limit setting)
This is the setting to stop the frame at Flame Limit (movable limit position). To stop at Frame Limit, it is
necessary to be memorized the frame origin correctly by the machine. The position where the frame stops
differs in every "Frame Type". This function is not applicable for L-spec. machine.
4-4-1. Screen
4-4-2.
How to operate
The following is an example that the frame is stopped at Frame Limit.
(1)
Set to main screen.
(2)
To press F1 key while pressing SET
Stop at Frame Limit
YES: To stop (usual setting)
NO: Not to stop
Selecting "NO" will not display the following
message at data input.
Selecting "NO" will not stop the frame at frame limit. The frame could interfere with the
peripheral part resulting in its breakage.
6 Frame Limit Setting
NO
OK to move a frame to the
start point of design data ?
CAUTION
!
6(7 6(7
)
1 Password (Functional Limit)