Symmetricom TimeSource 3600, Manual

Page: 151 / 254

TL1 Reference
151
2
4
5
S S S S S S S S S S S S S S S S S S S S S S S S S S S S S
4
Edit Equipment (cont’d)
The parameters which can be entered in the <spec_block> are
listed below. For any specific <aid> entered in a command, only
certain parameters are valid. For each valid parameter, choose the
appropriate value from the Value column. When entering multiple
parameters, separate the parameters with commas
.
Aid Parameter Value Description
TS3600 TOD=a a = CISCO Serial message sent in Cisco format
a = NTP4 Serial message sent in NTP Type 4 format
a = NONE No serial message sent
ALMCOND =a a = ALW Alarm conditioning for E1, TOD, and IRIG-B
outputs is enabled
a = INH Alarm conditioning for E1, TOD, and IRIG-B
outputs is disabled
IPNE=a.b.c.d
(See Note 1) a = 0 to 255 IP address of this TimeSource 3600
(command must be sent from COM1,
COM2, or Craft port to set this parameter)
b = 0 to 255
c = 0 to 255
d = 0 to 255
IPSUBNET=a.b.c.d
(See Note 1) a = 0 to 255 Subnet mask for this TimeSource 3600
(command must be sent from COM1,
COM2, or Craft port to set this parameter)
b = 0 to 255
c = 0 to 255
d = 0 to 255
BYPASS=a
(990-72060-04
systems only) a = AIS When the ESCIU detects an LOS on an input
spans, AIS is output to the NE (the E1
alignment sequence is blocked)
a = PASSTHRU When the ESCIU detects an LOS on one of its
input spans, the E1 alignment sequence is passed
through to the NE with the original input alarm