Symmetricom TimeSource 3600, Manual

Page: 113 / 254

3
Installation
113
4
5
3
S S S S S S S S S S S S S S S S S S S S S S S S S S S S S
26 If not using an Element Manager, skip to Step 28. If not using a separate port to
send autonomous messages to an Element Manager, skip to Step 27. Use the Edit
Equipment command to set the IP address and port address of the Element
Manager. Port 5550 connects to this address when the TimeSource 3600 develops
a TL1 autonomous message, sends any messages, and closes the connection. An
alternate Element Manager may be set up in case port 5550 cannot make a
connection to the primary Element Manager.
ED-EQPT::TS3600:<ctag>:::IPEM1=a,IPEM1PORT=b[,IPEM2=a]
[,IPEM2PORT=b][,
IPINACT=c] ;
IPEM1=a =Primary Element Manager’s IP address in the form a.a.a.a
(each a is an independent value of 0 to 255)
IPEM1PORT=b =Primary Element Manager’s Ethernet port address
(b = 0 to 65535)
IPEM2=a =Alternate Element Manager’s IP address in the form a.a.a.a
(each a is an independent value of 0 to 255)
IPEM2PORT=b =Alternate Element Manager’s Ethernet port address
(b = 0 to 65535)
IPINACT=c =Disconnects from the Element Manager if an autonomous
message is not developed during this number of 100-ms
units of inactivity (0 to 10,000, where 0 deactivates the
timer)
Procedure G. Power Up (cont’d)
Step Procedure