Sym Quad Raider 600, Service Manual

Page: 229 / 247

18. ELECTRICAL SYSTEM
18-5
Charging System
Charging circuit
Current Leakage Inspection
Turn the main switch to OFF position, and remove
the negative cable terminal (-) from the battery.
Connect an ammeter between the negative cable
terminal and the battery negative terminal.
Caution
In the current leakage test, set the current
range at the largest scale, then gradually
decrease to the lower scale as the test
process goes to avoid possible damage to
the ammeter and the fuse.
Do not turn the main switch to ON position
during test.
If the leaked current exceeds the specified value, it
may indicate a short circuit.
Allowable current leakage: Less than 1mA
Disconnect each cable one by one and take
measurement of the current of each cable to
locate the short circuit.
AC. Generator
Regulator rectifier
Main switch
Fuse 20A
Battery
Green
Yellow Black
Red
Yellow
Yellow
Battery negative terminal
To this chapter contents